DEPENDENCE OF TENSILE FORCE OF THE ELASTIC LIMIT STATE OF ROPES FROM THE BENDING PARAMETER ON THE DRUM
DOI:
https://doi.org/10.31650/2786-6696-2023-5-24-35Keywords:
rope, strength characteristics, calculation scheme, bending parameter when winding on a drum, calculation method for static strength.Abstract
Based on the method previously developed by the authors for the analytical determination of the ultimate elastic state of the ropes, the dependence of the tensile force with the winding of the rope on the drum on the parameter (the ratio of the diameters of the drum and the rope) in the interval . Dependence was determined for two loading schemes of rope: stretching of the rope with winding on the drum with a freely suspended load and stretching of the rope with winding on the drum with the load in the guides. Based on the developed method, the dependence of was performed for 16 kantais of different designs. The tensile strength is presented in the relative form ( total breaking strength of the rope wires). The effort significantly depends on the construction of the rope and the bending parameter . In the section the force increases monotonically and practically linearly, reaching the value corresponding to the calculation scheme of stretching a straight rope. For different structures with the parameter change in force with . In the section the dependence is not linear, at . The section is characterized by a sharp change in force , with the bending parameter . For most rope designs at the forces are close to zero values. When stretching with a freely suspended load, the forces are 1.6–1.7 times lower than when stretching in guides. For twisting ropes (one-way winding), the ratio is 2.5–3.4 times. In the normative methods of calculations of lifting ropes, the characteristics or are used, which do not take into account the peculiarities of the deformation and construction of the ropes. We believe that the given information is appropriate in solving the issue of building a methodology for calculating the static strength of lifting ropes based on the characteristics of their ultimate elastic state, which will ensure stable optimality of the use of ropes, will allow you to rationally choose the type of rope construction and its dimensions.
References
[1] V.I. Berezhinskiy, A.N. Shatilo, Zvukoizolyaciya pod styazhku pola kotoraya luchKanaty shahtnyh pod"emnyh ustanovok. Univesitetskaya kniga, Moskva, 2015.
[2] Pravila ustrojstva i bezopasnoj ekspluatacii gruzopod"yomnyh kranov. Fort, Har'kov͟, 2007.
[3] J. Reinl and M. Golder, "Wire Ropes in Crane Applications – Current State of the Standardization Work of ISO/WD 16625", InnoTRAC Journal, vol. 1, pp. 37–46, 2020, doi.org/10.14464.
[4] S.B. Budrin, A.I. Ilyin, V.V. Ovsyannikov, O.A. Smirnov, "Assessing the Integrity of Steel Ropes for Lifting Machines Based on Testing Data", IOP Conf. Series: Materials Science and Engineering, vol. 1079, 2021, doi:10.1088/1757-899X/1079/5/052013.
[5] DIN-Taschenbuch. Drahtseile: Normen. Berlin-Koln, Beuth, 1990.
[6] V.O. Malinovsky, Stal'nye kanaty: analiticheskij spravochnik. Odessa: Astroprint, 2016.
[7] Die Technischen Anforderungen an Schacht-und Schragforderanlagen (TAS). Stand: Dez. 2005 Bezirksregirung Arnsberg: Abt. Bergbau und Energie in NRW. Dortmund, 2005.
[8] I.M. Chaiun, Nesushchaya sposobnost' pod"emnyh kanatov i lent. Odessa, Astroprint, 2003.
[9] P.E. Vovk, I.M. Chaiun, "Rope limit state characteristics", Materials of conference «Actual problems of engineering mechanics», vol. 8, pp. 115-119, 2021.
[10] M.F. Glushko, Stal'nye pod"yomnye kanaty. Odessa, Astroprint, 2013.
[11] I.M. Chaiun, "Eksperimental'naya proverka modeli formirovaniya izgibnoj zhestkosti kanata", Stal'nye kenaty, vol. 3, рр. 56-63, 2003.
Downloads
Published
Issue
Section
License
Copyright (c) 2023 MODERN CONSTRUCTION AND ARCHITECTURE

This work is licensed under a Creative Commons Attribution 4.0 International License.




